bitcoinfere.blogg.se - Bluesuite no spi transport

#Bluesuite no spi transport how to#
#Bluesuite no spi transport install#
#Bluesuite no spi transport software#

Choose "SPI BCCMD", and if the connection is fine, the CSR USB-SPI device will show in “Port”, then click "OK". Make sure the connection is fine, then open PSTool in BlueSuite 2.5.0. C:Program FilesCSRBlueSuite 2.4driverswin32.

#Bluesuite no spi transport install#

Install USB-to-SPI driver Driver files can be found in below folder. We use USB-to-SPI device, so select USB SPI. One is using USB, the other is printer port. Only basic AudioB plus(CSR8635) need change this settings. There are 2 kinds of method in SPI debugging. Finally, click "Write Device", wait for a while the configuration file will be programmed to the chip.Īptx Bluetooth module can skip this step. "Input/Output->Input PIOs", Change the Analogue input PIO value to PIO17. Choose "CSRA64215 A11" and "USB SPI(180063)" on the top left, then click "Read Device". If the module chip model is A64215, then open CSRA64xxx Configuration Tool. At last, Click "Write Device", wait for a while the configuration file will be programmed to the chip, and at the same time below the interface will show the success of programming information.

Change to "Input/Output" Tab, Change the Wired input value to PIO17. If the identified chip model is CSR8635, you can proceed to the next step, otherwise try again.

#Bluesuite no spi transport software#

Click "Open From Device", wait a moment, the software will detect the chip model. The basic AudioB plus(based on CSR8635) and APTX AudioB plus(based on CSRA64215). Then the blue led and red led will flashes alternately. Make sure the first 6 pins have a good contact with the corresponding pads. You need to locate the single steel alignment pin of the connector into the single hole of the PCB footprint, then press down softly to engage the spring-pin contacts.

#Bluesuite no spi transport how to#

How to enable the Aux in function of Bluetooth moduleĬonnect the CSR USB-SPI programmer and Tag-Connect line with a AudioB Plus convert board, then connect CSR USB-SPI to your computer by a mini USB cable and windows will auto detect it and install the drivers.Ĭonnect TC2050-IDC-NL’s connector to AudioB plus programming port.

Download CSRA64xxx and CSRA63xxx Tools and install it (Aptx module - CSRA64215).

Download CSRXX_ROM_ConfigTool and install it (non-Aptx module -CSR8635).

Figure 10: Selecting USB transport Figure 11: Selecting SPI transport Americas. This article will introduce how to process it. For the exact procedure using BlueSuites PStools over these interfaces. You can use a CSR progarmmer change the module settings and turn this port on. PIn7,8 are Line in channel A, PIn9,10 are Line in channel B, But the module default settings has this port turned off. Tinysine AudioB plus Bluetooth audio module have a Aux in port.